For domestic hot water (supplied with unions 20mm / 25mm)
Features
- Motor protection IP44 (must be installed in weatherproof location)
- Maximum temperature for open systems (65°C)
- Minimum static head must be 2.5m or more for temperatures up to 80°C, 5.0m or more for temperatures up to 95°C and 18.0m or more for temperatures up to 110°C
Installation & Operating Conditions
- Pump must be used only in clean water service without any solids, grit, or dirt
- Pump to be installed such that the shaft is in a horizontal position
- Pump must be installed in a weatherproof location with proper ventilation and easy access
Technical Data
Item No. | HP | Power P1 (W) | 40W/67W/90W Speed 1/2/3 |
Inlet (mm) | 20 / 25mm Optional | Power Supply | 1Ph / 230v /50Hz |
Outlet (mm) | 20 / 25mm Optional | Full Load Amps | 0.17/0.29/0.39 speeds 1/2/3 |
Casing Length | 130mm W/O Unions | Max Work Press | 10 Bar |
Casing Material | Stainless Steel | Weight (Kg) | 2.5 (Approx) |
Speeds | Three | Dimensions | 130mm x 130mm x 130mm |
Note: The above performance chart is measured at pump outlet and based on factory test conditions. Actual performance onsite may differ due to piping and fixture sizing and layout.
For domestic clean hot water installed in a weatherproof location with proper ventilation and easy access.
Pump Model
HP (20mm union) /HP25 (25mm union)
Length (mm)
130
Width (mm)
130
Height (mm)
130
Weight (kg)
2.5 (Approx)
Inlet (mm)
20 (25mm Optional)
Outlet (mm)
20 (25mm Optional)
Casing Length
130mm W/O Unions
Casing Material
Bronze
Speeds
Three
Power (W)
40w/67w/90w speed 1/2/3
Power Supply
1Ph / 230v / 50Hz
Full Load Amps
0.17/0.29/0.39 speeds 1/2/3
Max Work Press
10 bar
PRODUCT DATASHEET